Home > ANTENNAS, ACCESSORIES, COAXIAL CABLES > AMATEUR ANTENNAS >

TRAM 1199 Scanner Mobile Antenna Glass Mount Wide Bands 25-1300 MHz with Cable and BNC Connector Assembled
TRAM 1199 Scanner Mobile Antenna Glass Mount Wide Bands


 
Our Price: $29.00


Availability:: Usually Ships in 24 Hours
Product Code: 1199
QTY:

Description
 
TRAM 1199 Mobile Antenna all bands 25-1300 MHz glass mount omnidirectional for scanner with 17' of RG-58/U and installed BNC male connector. 29" whip for exceptional reception. For mobile radio, scanner using BNC female antenna connector.

Important!!!
You must not install it over defroster wires or on highly tinted windows. If the glass on your car is tinted from the factory, (tint in the glass), there will be no interference with the antenna's performance. You also have to properly ground the unit from the matching box to the car's ground, and then you must carefully match the antenna to the system using either a good SWR meter or, better yet, a good RF watt meter. If you do the install right you should end up with an SWR of well under 2:1

Installation instructions: Decide where you want to mount the antenna and then wash and dry the window well, both inside and outside. Use an alcohol prep pad on both sides of the window and the mounting plates to clean anything off that your first wash missed. Make sure you give a minute or two for the alcohol to dry after you use it. Peel the protective plastic off the outside mounting plate and stick it to the window. Be careful to align the mount exactly where you want it – you have about 1 second to move it once it’s on the glass! BTW, the little threaded stud where the antenna whip is mounted goes UP! And the outside is stuck on, awaiting the antenna whip. Don’t put the whip on yet – the glue needs to set first. Repeat the plastic peeling / sticking with the inside unit. With the inside unit, make sure that the wire coming off of it is pointed the correct direction. Let everything sit for at least 2 hours so the glue can harden fully. Screw the whip on Put on the horizontal ground plane element on the coax connector, and attach the coax. Tune up the antenna. Tuning is pretty standard with a VSWR meter and a couple of hex wrenches.

Share your knowledge of this product. Be the first to write a review »